Tsymo Pet Feeder Manual Pdf (2024)

FAQs

How to reset automatic pet feeder? ›

Use the end of a paperclip to press and hold the reset/ reboot button for 3-5 seconds until the LED blinks white to show a successful reboot. If the feeder successfully reconnects to your Wi-Fi with internet, the LED will blink blue and then turn solid showing it is fully connected and operational.

Make sure the feeder LED is blinking white which shows it is functioning and searching for Wi-Fi. Look at your Wi-Fi settings and make sure you are using a 2.4gHz network. Check if any firewalls are activated on your router to keeping it from connecting. Power cycle the feeder by turning off the power switch.

Unlock: Press the Setting button and hold for 3s to unlock and enter the setting mode. Lock: Press the Return/Cancel button to return to lock mode. Still need help? Please submit a request via the contact form or send a message to help@petlibro.com.

Reset the feeder to factory settings, holding down the Add Pet ( ) button for 10 seconds (until the light starts alternating red / green and the lid opens and closes).

Press and hold the Up button and the Down button for three seconds to reset the feeder to factory settings.

If the Wi-Fi router and modem are yours, try turning them off and then on again. Unplug the router and modem's power cords from the power outlet for 15 seconds. Plug the power cords back in. Check that all cords and cables are secure at both ends.

Yellow Blinking Feeder has power and is in setup mode. Yellow Solid Smartphone is connected to the feeder in setup mode. Blue Blinking Slow Feeder is connected to Wi-Fi but no internet. Blue Blinking Fast Feeder is trying to connect to Wi-Fi or is offline.

The Smart Pet Feeder can be reset by pressing and holding the 'feed' button for 5 seconds until a sound is heard. A reset will erase all settings and data on the Smart Pet Feeder and return it to its original factory settings.

How do I change my dog's feed time? ›

Change time in increments of 15 minutes each week for four weeks. In week one instead of feeding at 5am/5pm provide a dog treat and go for a walk. Then feed at 5:15. The above chart is an example of how to gradually change your dog's feeding schedule.

Wait until feeder unblocks. If it's still blocked, the red light will remain flashing. The colour of the light remains the same under normal feeding. After feeding is done, if a problem is detected (i.e. Low battery, low food supply or food outlet fails to rotate), red light will be on after 2s.

"Outlet is blocked" means that something is in the channel of the food outlet, and it is sensed by the infrared light, that's why you receive the error message. You can troubleshoot via the steps below: 1. Clean the food outlet with a tissue and see if the error message still persists.

Once the feeder is set up, it will continue dispensing food even if the Wi-Fi is temporarily disconnected. You can also manually feed your pet by pressing the feed button on the machine.

The Smart Pet Feeder can be reset by pressing and holding the 'feed' button for 5 seconds until a sound is heard. A reset will erase all settings and data on the Smart Pet Feeder and return it to its original factory settings.

1. How to restart the Fresh Element Mini Pro? Unplug the power cord and plug it in again to restart the device. If there are batteries in the device, remove the battery and reinstall it.

If your feeder has a flashing light indicating that it is offline, the feeder will continue to feed as previously scheduled if it has power. Verify home internet is working. If other wireless devices have also lost connection, consider resetting your router and/or contacting your internet service provider.